Download Print this page

Lanier 480-0066 Material Safety Data Sheet

Toner for lanier 5613

Advertisement

Quick Links

Identity:
5613 Toner
Product ID:
480-0066
Synonyms
& Common
Toner for Lanier 5613
Names:
Lanier 5613
Uses:
Chemical
Mixture
Formula:
Polyester resin
Styrene acrylic polymer
Carbon black
Dye
Carnauba wax
3
*PEL as the product: 15mg/m
3
*TLV as the product: 10mg/m
HMIS Rating:
FLAMMABILITY = 1
REACTIVITY = 0
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any non-
toxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): A manufacturer sponsored chronic inhalation study in rats using a special test toner
revealed there were no lung changes at all in the lowest exposure level (1mg/m
slight degree of fibrosis was noted in 25% of the animals at the middle exposure level (4mg/m
at the highest exposure level (16mg/m
amount of any dust retained in the lungs for a prolonged interval. The special test toner was ten times more respirable than commercially
available toner to comply with EPA testing protocol and would not function properly in Xerographic equipment.
Carbon Black is listed on the IARC Monograph and the Massachusetts Substance List. The IARC has evaluated the evidence for the
carcinogenicity of Carbon Black as inadequate to determine a carcinogenic risk for humans.
This product contains no known hazardous materials as defined by the OSHA Hazard Communication Standard 29 CFR 1910.1200.
Remove to fresh air if effects occur. Get medical
Inhalation:
attention if needed.
Skin Contact:
Wash with soap and water.
Suitable extinguishing media: CO
Extinguishing media which may not be used for safety reasons: none
This material will burn in case of fire. The decomposition products are CO, CO
Special protective equipment for fire fighters: none
UEL: n/a
LEL: n/a
MATERIAL SAFETY DATA SHEET
Section 1: Chemical Product and Company Information
Section 2: Composition / Information on Ingredients
PERCENT
50 - 80
10 – 40
< 15
< 5
< 5
3
(total dust), 5mg/m
(respirable dust)
3
(total dust), 5mg/m
(respirable dust)
Section 3: Hazards Identification
HEALTH = 1
SPECIAL = none
3
) in all animals. These findings are attributed to "Lung Overloading", a generic response to excessive
Section 4: First Aid Measures
Section 5: Fire Fighting Measures
, dry chemical, foam or water.
2
Emergency Telephone: (800) 526-4371
MSDS No.
CP- 345
Issued:
09/20/01
Supersedes:
None
Date:
09/20/01
Prepared by:
EH&S Department 770-496-9500
Approved by:
Larry Choskey, Manager, CEH&S
European
Walter Fricke, Manager, Safety &
Contact:
Environment,
Lanier Worldwide, Inc.
Im Taubental D-41468 Neuss,
Germany +49-2131-387-177
CAS No.
EXPOSURE LIMITS
0-00-0
8 mg/m
25767-47-9
1333-86-4
3.5 mg/m
31714-55-3
8015-86-9
3
), the most relevant level to potential human exposures. A very
3
), while a slight degree of fibrosis was observed
In case of contact, immediately flush eyes with
Eye Contact:
water for 15 minutes. Get medical attention if
needed.
Ingestion:
Dilute stomach contents with several glasses
of water. Get medical attention.
, and No
. Avoid inhalation of smoke.
2
x
Lanier Worldwide, Inc.
2300 Parklake Dr., N. E.
Atlanta, GA 30345-2979
SOURCE
3
3
N/a
10 mg/m
Not listed
N/a
3
3
OSHA PEL ACGIH TWA
3.5 mg/m
Not listed
N/a
Not listed
N/a

Advertisement

loading

Summary of Contents for Lanier 480-0066

  • Page 1 MATERIAL SAFETY DATA SHEET Section 1: Chemical Product and Company Information Identity: 5613 Toner Product ID: 480-0066 Synonyms & Common Toner for Lanier 5613 Names: Lanier 5613 Uses: Chemical Mixture Formula: Section 2: Composition / Information on Ingredients Polyester resin...
  • Page 2 Used Toner should be disposed of under conditions that meet all federal, state and local environmental regulations. Disposal regulations vary from locality to locality; therefore consult your local Lanier office or the EPA to determine the proper method for disposal. Do not incinerate loose or spilled Toner.
  • Page 3 MATERIAL SAFETY DATA SHEET Page 3 CP-345 consequences of its use. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we do not guarantee that these are the only hazards that exist. Information on this data sheet represents our current data and best opinion as to the proper use in handling of this product under normal conditions.

This manual is also suitable for:

5485 toner 480-00345613