Lanier 480-0021 Material Safety Data Sheet

Identity: Black Toner for 5365
Product ID: 480-0021
Synonyms
& Common Black Toner for
Names: Lanier 5365, 5355, 5555, 5565, 5580,5480
Uses: Lanier 5365, 5355, 5555, 5565, 5580, 5480
Digital Copier
Chemical
Formula: Mixture
Styrene acrylate copolymer
Carbon black
Inorganic pigment
Organic pigment
3
*PEL as the product: 15mg/m
3
*TLV as the product: 10mg/m
HMIS Rating:
FLAMMABILITY = 1
REACTIVITY = 0
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any non-
toxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): A manufacturer sponsored chronic inhalation study in rats using a special test toner
revealed there were no lung changes at all in the lowest exposure level (1mg/m
slight degree of fibrosis was noted in 25% of the animals at the middle exposure level (4mg/m
at the highest exposure level (16mg/m
amount of any dust retained in the lungs for a prolonged interval. The special test toner was ten times more respirable than commercially
available toner to comply with EPA testing protocol and would not function properly in Xerographic equipment.
Carbon Black is listed on the IARC Monograph and the Massachusetts Substance List. The IARC has evaluated the evidence for the
carcinogenicity of Carbon Black as inadequate to determine a carcinogenic risk for humans.
This product contains no known hazardous materials as defined by the OSHA Hazard Communication Standard 29 CFR 1910.1200.
Remove to fresh air if effects occur. Gargle with
Inhalation: water. Get medical attention if needed.
Skin Contact: Wash with soap and water.
Suitable extinguishing media: CO
Extinguishing media which may not be used for safety reasons: none
Flammability: Product will burn in case of fire. The decomposition products are CO, CO
Special protective equipment for fire fighters: none
UEL: n/a LEL: n/a
MATERIAL SAFETY DATA SHEET
Section 1: Chemical Product and Company Information
Section 2: Composition / Information on Ingredients
PERCENT
> 90
5 - 7
1 - 2
1 – 2
3
(total dust), 5mg/m (respirable dust)
3
(total dust), 5mg/m (respirable dust)
Section 3: Hazards Identification
HEALTH = 0
SPECIAL = none
3
) in all animals. These findings are attributed to "Lung Overloading", a generic response to excessive
Section 4: First Aid Measures
Section 5: Fire Fighting Measures
, dry chemical, foam or water.
2
Section 6: Accidental Release Measures
Emergency Telephone: (800) 526-4371
MSDS No. CP- 332
Issued: 05/22/2003
Supersedes: 04/30/2001
Date: 05/22/03
Prepared by: EH&S Department 770-496-9500
Approved by: Larry Choskey, Manager, CEH&S
European Contact: Walter Fricke, Manager, Safety & Environment,
Lanier Worldwide, Inc.
Im Taubental D-41468 Neuss, Germany
+49-2131-387-177
CAS No. EXPOSURE LIMITS
25036-16-2
9010-79-1
1333-86-4 3.5mg/m
25869-00-5
104815-18-1
3
), the most relevant level to potential human exposures. A very
3
), while a slight degree of fibrosis was observed
In case of contact, immediately flush eyes with
Eye Contact: water for 15 minutes. Get medical attention if
needed.
Ingestion: Dilute stomach contents with several glasses
of water. Get medical attention if needed.
Unusual Fire and Explosion Hazards: Toner material, like most
organic material in powdered form, is capable of creating a
dust explosion.
, and No . Avoid inhalation of smoke.
2 x
Lanier Worldwide, Inc.
2300 Parklake Dr., N. E.
Atlanta, GA 30345-2979
SOURCE
N/a N/a
3 3
OSHA PEL ACGIH TWA
3.5mg/m
N/a N/a
N/a N/a