Epson Stylus COLOR 800 Service Manual page 140

EPSON Stylus &RORU 800
10. Look at the output to check if the lines for black and color are most closely aligned. If not, input the
proper value to adjust the misalignment according to the result, as shown in the figure below.
; The printed vertical line shift about 0.07mm by inputting "4" on 200 cps adjustment mode and "2"
on 100cps adjustment mode.
11. If the value input is incorrect, enter the correct value after pressing the "SPACE" key and press
"ENTER" key to set the values, then the menu returns to the sub menu.
12. Enter "7" for "Select menu : ?" and press "ENTER" key to proceed to "Print Inspection" in the sub
menu in order to check how the set values affect to the outcome. The menu appears is as follows;
4-20
Download Service Manual and Resetter Printer at http://printer1.blogspot.com
Black
Color
Direction in which
the paper is fed
Black
Value to Enter:
Minus
Figure 4-28. Adjusting Value Determination
CAUTION
Input M/C No. : ?
M/C No.
Black voltage value :
Color voltage value :
Figure 4-29.
Setting Menu (1) for Print Inspection
Input M/C No. : ?
Black voltage value : 24B16
Color voltate value : 14B14
OK? ('Return'
M/C No.
Black voltage value :
Color voltage value :
Figure 4-30.
Setting Menu (2) for Print Inspection
Black
Color
Black
Value to Enter:
Plus
:
to NEXT) :
:
Rev. A