Epson TM-L90 User Manual page 10

English
4. Push the roll paper spacer until you feel it clicks onto the shaft.
Check that the roll paper spacer slides smoothly to the left and right.
Hook
Shaft
5. Slide the roll paper spacer to the appropriate width.
You can use the measurement printed inside the printer, aligning the inside edge of
the spacer with the desired measurement.
Note:
When you want to set the roll paper width from 61 mm to 70 mm, break off by
hand the two tabs of the spacer. (You can still also use widths from 38 mm to
60 mm with the spacer with the tabs broken off.)
6. Tighten the spacer with the screw included with the spacer.
(Although there are two holes, this is the only one to put the screw in.)
Hole for screw
10 TM-L90 User's Manual
Inside edge
Ruler