How To Insert Forms; Continuous Forms; Forms Path For Singlepart Forms; Forms Path For Multipart Forms - IBM 5110 Basic Reference Manual

214
HOW TO INSERT FORMS
Continuous Forms
Form Guide Rack
1
~f.;.:
Release Lever
j-;.per.ldvance Knob
Vernier Knob
Forms Path for Singlepart Forms
/Forms Guide Rack
~========~=:
\(in lower position)
1. Slide the printer cover forward.
2.
3.
4.
5.
6.
7.
Push the print head to the extreme left position.
For singlepart forms pivot the form guide rack
up and forward to a vertical position. For
multipart forms, leave the forms guide rack in
the horizontal position.
The diagrams below show the proper forms path
for singlepart and multipart forms.
Push the paper release lever to the rear to
activate the friction feed rolls.
Place the forms on the table behind the printer.
Note: The forms must be positioned behind the
printer so that the forms feed squarely into the
printer.
Thread the paper down, over the rollers, behind
the tractors, and behind the platen.
Turn the paper-advance knob to move the
paper around the platen until you can grasp it
with your fingers.
Forms Path for Multipart Forms
~~~~!!.;;:~~iiIt·
Forms Guide Rack
Position these guides (----'
at the edge of the
pape~>
.