Table of Contents
Advertisement
Using Single Sheets of Paper or Forms
Your printer uses either single sheets or continuous
multiple-copy (up to four-part) fornis. Single sheets
can be from 178 mm (7 in.) to 305 mm (12 in.) wide
and from 216 mm (8.5 in.) to 432 mm (17 in.) long.
The forms can range in widths from 89 mm (3.5 in.) to
390 mm (15.75 in.) including perforations.
The figure below shows forms being loaded from the
front of your printer. Rear and bottom loading slots are
shown at the end of this section. Single sheets can be
loaded only at the front loading slot.
The following two sections describe how to use either
type of paper. Each section is complete and
independent of the other. To use continuous paper or
forms, see "Continuous Paper and Forms Operation"
on the next page. To use single sheets, see "Single
Sheet Operation" later in this option.
Note: Your printer is designed to operate with the
access cover closed. Operating your printer with
the access cover open may cause the paper or forms
to jam in your printer.
lr--_
/
\
"""
L
I
Front Loading
IBM Color Printer 5-57
Advertisement
Table of Contents
