Using The Doors - Samsung RF30HB User Manual

• Tilt up the front of the drawer and pull it straight
out. Then, move the drawer slightly in the
direction of the arrow and pull it out of the
refrigerator. See the illustration below.
- To re-install : Insert the drawer into the frame
rails, and then push back into place.
- Slide each bin in above the desired location,
and then push down until it stops.
CAUTION
The drawers need to be removed before the glass
shelf above them can be lifted out.
5. Flex Zone
- To remove the Flex Zone : Pull the Flex door
out to full extension. Lift the Flex Zone up,
pulling it to your body with both hands.
- To re-install the Flex Zone : Open the Flex
door to full extension. Tilt the front of the Flex
Zone up, place the back of the Flex Zone onto
the rails, and then lower the front until the whole
Zone rests on the rails.
DA68-03030A-01.indb 33 DA68-03030A-01.indb 33
When the Flex Zone or LED lighting is not
working, check the connectors [ ( 1 ), ( 2 )
shown below ] for cracks or leaks.
1. Disassemble the Flex Door. Refer to page 13
for disassembly instructions.
2. Open the cover rail cap with a fl at-head screw
driver to examine the connectors.

Using the doors

Ensure that the doors close all the way and are
securely sealed.
When the refrigerator door is only partially open, it
will automatically close. If the door is opened more
than its auto close range, it will remain open. You
must close it manually.
English - 33
(2) (2)
(1) (1)
2014. 5. 13. 2014. 5. 13. 2:15 2:15