Sat-Mouse - Operation Without Remote Control - Ten-Haaft HD receiver Europe Operating Instructions Manual

2.2 Sat-mouse -
1
1
Sat-mouse connector (RJ-45)
4
Remote control receiver
The two buttons on the sat-mouse allow you to control the following basic
functions of the receiver when the remote control is not
available:
Changes to the next channel in the channel list.
Changes to the previous channel in the channel list.
Press both buttons briefl y at the same time to toggle between RADIO and TV mode. Holding
both buttons down will cause the receiver to switch off. This corresponds to pressing the red
stand-by button (ON/OFF) on the remote control.
When in stand-by mode, a brief press on both buttons switches the receiver back
on. When in „power-saving" stand-by mode, the receiver can only be switched
on using the button combination.
Another control element is the master switch on the front of the receiver.
In position „0" or „OFF", the receiver is isolated from the vehicle's power supply.
The switch must be in position „I" or „ON" for the receiver to operate.
Should the receiver no longer respond to commands, set the master switch to „0"
for approx. 10 seconds and then back to „I".
operation without remote control
2
Left sat-mouse button
5
Right sat-mouse button
6
3
2
4
5
3
Display