Ci Common Interface Module - Ten-Haaft HD receiver Europe Operating Instructions Manual

4.2 Common Interface module
Common interface
Slot: No module
MENU : Back
At the front of the device there are is one slot for modules decoding encrypted
programs.
To prevent damage, only modules with the „PC Card" logo must be inserted. Any
other module may damage the receiver beyond repair.
Do not use excessive force to insert the module. Rather pull the module back out
of the slot and try inserting it again. Ensure that you insert the module with the
correct side up.
Smartcards are sometimes printed in a confusing way as they are often designed
to be used with other decoders. Most Common-Interface modules are designed to
accept cards with the golden contacts facing upward. Before inserting a smartcard
into the Common-Interface module, make sure that the usually gold-coloured con-
tacts on the smartcard are clean and free of dust.
If a decoder module has been correctly identifi ed, its name is displayed in the main
menu under „Encryption". When you select the entry for this module in the list and
press OK, a menu will be displayed that is provided by the decoder module. Please
contact the module manufacturer in case of any questions concerning the module.
Note: Some modules only log in completely and provide a menu system if a
valid smartcard is inserted. The OK and EXIT buttons are used to navigate
within the manufacturer-specifi c menus. If a menu does not respond to the OK
or EXIT command, the dialog can be cancelled by pressing MENU. The receiver
then interrupts the connection to the module's menu system.
EXIT : Close menu
18