Troubleshooting - Desa Wireless Chime User Manual

Snap-On Cover: Apply pressure to the cover until it snaps into place (see Figure A). To re-
move, firmly grasp cover and pull to remove from base.
Hanging Cover: Before mounting chime base to wall, slide the cover pin that will be on top of
the mounted base out of the base. Turn it over so the pin is protruding above the base. Slide the
cover pin into base (see Figure B). Hang cover on cover pin.
Note: Cover pins are located on two sides of the chime base for use with hanging covers. When
chime base is mounted according to mounting orientation marking, use the cover pin located on
the top of the chime base for hanging the cover.
'D '
P E
T Y 2 0
L R
T R
'D '
P E
T Y
2 0
L R
Snap-On
Cover
Figure A
Chime does not sound:
• Make sure pushbutton and chime codes are the same (See pages 2 and 3).
• Check orientation of pushbutton battery (See page 3).
• Check charge of pushbutton and chime batteries, replace if necessary.
Batteries seem OK, but the chime does not work when installed:
• Do not mount chime or pushbutton on metal or near metal studs. This reduces the transmit-
ter range. Use 1/4" to 1/2" (6 to 13 mm) wood shims to move chime or pushbutton off metal
surface.
• Concrete floors may reduce range. Move chime away from floor.
• Try locating chime closer to pushbutton.
The range of the wireless chime can vary with location, temperature and battery condition.
ATTACHING CHIME COVERS
Mounted
Chime Base
X
- R
3 5
- 0 0

TROUBLESHOOTING

Chime Base
-4-
Cover Pin
Figure B
598-1172-00