Checking The Bulbs And Bulb Sockets - Yamaha 2005 BT1100 Supplementary Service Manual

CHECKING THE BULBS AND BULB SOCKETS

EAS00732
CHECKING THE BULBS AND BULB
SOCKETS
Check each bulb and bulb socket for damage or
wear, proper connections, and also for continuity
between the terminals.
¡
Damage/wear Repair or replace the bulb, bulb
socket or both.
Improperly connected
Incorrect continuity reading
the bulb, bulb socket or both.
TYPES OF BULBS
Le lampadine utilizzate su questo motociclo sono
illustrate nella figura a sinistra.
• The bulbs used on this motorcycle are shown in
the illustration on the left.
• Bulbs A and B are used for headlights and
usually use a bulb holder which must be de-
tached before removing the bulb. The majority of
these bulbs can be removed from their respec-
tive socket by turning them counterclockwise.
• Bulb C is used for turn signal and tail/brake
lights and can be removed from the socket by
pushing and turning the bulb counterclockwise.
• Bulbs D and E are used for meter and indicator
lights and can be removed from their respective
socket by turn D and pulling E them out.
CHECKING THE CONDITION OF THE BULBS
The following procedure applies to all of the bulbs.
1. Remove:
• bulb
52
ELEC
¡
Properly connect.
¡
Repair or replace