Yamaha 2005 BT1100 Supplementary Service Manual page 52

HANDLEBAR
5. Install:
• master cylinder holder 2
10 Nm (1.0 m•kg)
NOTE:
Install the master cylinder holder 2 with the mark
"UP" facing up.
6. Install:
• clutch lever holder 1
NOTE:
Align the slit in the clutch lever a holder with the
punch mark in the handlebar.
7. Install:
• left handlebar switch 2
NOTE:
Aligh the matching surface on the handlebar
switches with the punch mark a on the handle-
bar.
8. Install:
• clutch cable
9. Connect:
• clutch switch coupler
NOTE:
Apply a thin coat of lithium soap base grease onto
the end of the clutch cable.
10. Adjust:
• clutch cable free play
Refer to "ADJUSTING THE CLUTCH
CABLE FREE PLAY" in Chapter 3.
Clutch cable free play (at the end of
the clutch lever)
5 10 mm
11. Adjust:
• throttle cable free play
Refer to "ADJUSTING THE THROTTLE
CABLE FREE PLAY" in Chapter 3.
Throttle cable free play (at the flange
of the throttle grip)
3 5 mm
44
CHAS