Mercedes-Benz S-Class Coupe 2015 Operator's Manual page 210

Hide thumbs Also See for S-Class Coupe 2015:
Table of Contents

Advertisement

Driving systems
208
if the camera lenses are dirty or covered.
R
Observe the notes on cleaning
(
page 330)
Y
if the vehicle components in which the
R
cameras are installed are damaged. In this
event, have the camera position and setting
checked at a qualified specialist workshop.
Do not use the 360° camera in this case. You
can otherwise injure others or cause damage
to objects or the vehicle.
The guide lines in the COMAND display show
the distances to your vehicle. The distances
only apply to road level.
i
The camera in the rear area is protected
from raindrops and dust by means of a flap.
This flap opens when the 360° camera is
activated.
The flap closes again when:
you have finished the maneuvering proc-
R
ess
you switch off the engine
R
you open the trunk
R
Observe the notes on cleaning
(
page 330).
Y
For technical reasons, the flap may remain
open briefly after the 360° camera has
been deactivated.
Activation conditions
The 360° camera image can be displayed if:
COMAND is switched on (see the separate
R
operating instructions)
The
360° Camera
360° Camera
R
i
If the 360° camera is activated at speeds
above approximately 19 mph (30 km/h), a
warning message appears.
The warning message disappears if:
the vehicle's speed falls below approx-
R
imately 19 mph (30 km/h). The 360°
camera is then activated.
the message is confirmed with the %
R
button.
function is switched on.
Switching the 360° camera on and off
using the button
To switch on: press button :.
X
Depending on whether position D or R is
engaged, the following is shown:
full screen display with the image from
R
the front camera
full screen display with the image from
R
the rear view camera
To deactivate: press button : again.
X
i
You can also switch to the split-screen
view from the full-screen view.
Activating the 360° camera with
COMAND
Press the Ø button in the center con-
X
sole.
The vehicle menu is displayed.
To select the 360° camera: turn and press
X
the controller.
Depending on whether position D or R is
engaged, the following is shown:
a split screen with top view and the
R
image from the front camera or
a split screen with top view and the
R
image from the rear view camera
Further information on the COMAND control-
ler can be found in the separate operating
instructions.

Advertisement

Table of Contents
loading

Table of Contents