Setting Send Restriction; Setting Reception Restriction - Kyocera Mita FS-1128MFP Operation Manual

Setting Send Restriction

You can restrict the other parties to which you send originals only to the ones registered in Permit FAX No. and
Permit ID No. as well as the ones registered in the Address Book. To change the sending restriction, follow the
steps below.

Setting Reception Restriction

You can restrict incoming faxes so that you only receive originals from senders registered in Permit FAX No. and
Permit ID No. and senders registered in your Address Book. This mode also allows you to set a [Reject List] for
Reception Restriction so that reception from senders on the list of Rejected FAX numbers or from senders
whose Local FAX Number is not registered are rejected. To change the reception restriction, follow the steps
below.
OPERATION GUIDE
12
To change and delete other Permit ID numbers,
repeat step 2 to 11.
1
Press the System Menu/Counter key.
2
Press the or key to select [FAX].
3
Press the OK key.
4
Press the or key to select [TX/RX Restrict.].
5
Press the OK key.
6
Press the or key to select [TX Restriction].
7
Press the OK key.
8
Press the or key to select sending restriction.
To not use the sending restriction, select [Off]. To
restrict the other parties only to the ones registered
in Permit FAX No. and Permit ID No. as well as the
ones registered in the Address Book, select
[Permit+Addr Book].
9
Press the OK key.
1
Press the System Menu/Counter key.
2
Press the or key to select [FAX].
3
Press the OK key.
4
Press the or key to select [TX/RX Restrict.].
5
Press the OK key.
6
Press the or key to select [RX Restriction].
7
Press the OK key.
Setup and Registration
6-23
6