Table of Contents
Advertisement
16
en | Assign & store
6.1
Temporarily PC with 2 serial ports
The following preconditions of Assign & store are required:
1.
2.
3.
4.
6.1.1
Start configure
1.
CAUTION!
When the connection with the DCN system or Camera system fails the following error
messages could appear:
–
–
–
2.
6.1.2
Assigning the overview
The Overview camera gives a general overview of the conference venue when all the
microphones are off. In case of Allegiant the Overview can also be used when an AutoDome
camera is moving from one preposition to another.
To assign:
1.
2.
3.
4.
After assignment of the Overview the first unit is selected to have a Camera: and Preposition
assigned. The Overview camera can be either a non moveable or moveable (AutoDome)
camera. However, when AutoDome is selected as Camera system, the Overview is always a
preposition of the AutoDome.
DCN-SWSACC_V4.0 | V1.0 | 2011.10
Both the DCN system and the Camera system are properly connected and have the
correct settings. Refer to Section 2 Installation for more details.
PC Communication Settings under workflow Section 4 System must correspond with the
hardware installation.
The Section 4.2 Video Url must be defined to view the AutoDome video in the browser
window.
Continue with Section 6.1.1 Start configure.
Click the Start configure button.
–
The Start configure button changes into Stop configure button.
Connection failure. Refer to Section 4.1 PC Communication Settings
Incompatible version of the DCN system.
Required authorizations missing.
Now all connected units are retrieved from the DCN system. While retrieving a progress
window will be shown. If all units are retrieved they are shown in the Assignment list. By
default the first item in the list is selected, this is the Overview. This Overview will be
shown during the conference if none of the microphones is active or when the Camera
movement time: is not elapsed. The Overview (camera 1) is selected within the
Assignment list.
Select a Camera:
Select a Preposition if the selected camera is a moveable camera.
Move the camera to the desired position.
Click the Assign & store button. The Camera: and Preposition are assigned to the
Overview and are stored in the Camera system.
Software Manual
Bosch DCN Standalone Automatic Camera
Bosch Security Systems B.V.
Control
Advertisement
Table of Contents
