Removing The Itb Unit - Canon LBP5050 Series Service Manual

Chapter 3
2) Remove the left cover. (page 3-2)[Removing the Left Cover]
3) Remove the rear side cover. (page 3-1)[Removing the Rear Side Cover]

3.3.1.2 Removing the ITB Unit

LBP5050N / LBP5050
1) Open the front door [1].
2) Pull out the cartridge tray [1].
3) Push the claw [1] in the direction of the arrow [A], and remove the right
stopper [3] in the direction of the arrow [B] while pushing the right corner
[2] of the upper cover assembly.
4) Push the claw [4] in the direction of the arrow [C], and remove the left
stopper [6] in the direction of the arrow [D] while pushing the left corner
[5] of the upper cover assembly.
[6]
[5]
[ C ]
[ D ]
[4]
5) Remove the cartridge tray [1].
6) Disconnect the connector [1] and free the harness [3] from the harness
guide [2].
3-16
[1]
F-3-69
[1]
F-3-70
[3]
[2]
[ B ]
[ A ]
[1]
F-3-71
[1]
F-3-72
0018-7136
7) Remove the ITB fixing holder [1].
- 1 screw [2]
[1]
[2]
8) Hold the ITB unit [1] as shown in the following figure and remove it in
the direction of the arrow.
- Be sure not to touch the ITB [1].
- Be sure to hold the plate [2] pull it out forward.
- Be sure not to deform the plate [2].
[1]
[3]
[2]
F-3-73
F-3-74