Remote Panic Operation - Prestige APS-43HJ Owner's Manual

To override the system:
1. Open the vehicle door. The alarm will sound.
2. Turn the ignition key to the on position.
3. Within 10 seconds, press and release the valet push button switch.
The alarm system will stop sounding and enter the disarmed mode. You can now start and
operate the vehicle normally.
Typically this override mode is used only if the transmitter has become inoperative. You may
elect to enter the VALET mode until repair or replacement of the transmitter, after which,
returning the system to the full operation mode is necessary. To do so, see the heading VALET
SWITCH.
ELIMINATING THE NORMAL ARM / DISARM CHIRPS
As explained earlier in the manual, you can eliminate the chirps selectively any time you arm or
disarm the system simply by pressing both transmitter buttons. If you find the normal arming and
disarming chirps annoying, they can be turned off permanently, eliminating the need to press
both buttons. To turn chirps off permanently, selectable features # 6 & 7 must be turned off in
the feature programming section of the installation manual. Refer to this manual or consult with
your installation technician to have this feature turned off.
NOTE : Whenever the chirps are bypassed, the 4 chirp intrusion indicator and 3 chirp defective
zone indicator will always operate. Since these are important warnings to you that something
has happened, they cannot be eliminated.
SENSOR DEFEAT FROM THE TRANSMITTER
This system has the ability to allow the sensor to be defeated, from the transmitter, entirely for
one arming cycle. To eliminate the sensor for one arming cycle:
Arm the system by pressing the arm button of the transmitter one time.
If within 3 seconds of arming the system you press the arm button a second time, the sensor
will be defeated for one arming cycle. If the system emits two chirps, you waited too long and
inadvertently disarmed the system.

REMOTE PANIC OPERATION

The ARM or DISARM button on your keychain transmitter also functions as a panic switch for
use in emergency situations. To use remote panic,
1. Press and hold the ARM or DISARM button on the keychain transmitter for 3 or
more seconds. The alarm will immediately sound.
2. To stop the alarm, press and hold the ARM or DISARM button on the transmitter
again for 3 seconds. If the button is not pressed, the alarm will automatically stop
after 30 seconds.
ADDITIONAL REMOTE FUNCTION ( CHANNEL 2 )
This security system has an additional feature that can be connected to a number of different
optional accessories. Some of the more common uses for this channel are;
o Remote Trunk Release
o Remote Car Starter
o Remote Window Closure
To activate the optional accessory, press and hold button 2 on the keychain transmitter for two
seconds.
Page 12
128-7126
12 of 16