Basic Setup / Tv View Operation; Selecting The Tv Aspect Ratio; Initial Setting - FUNAI WL6D-M102 Owner's Manual

Basic Setup / TV View Operation

Initial Setting

When you turn on this unit for the first time, you need to follow
these steps.
1
Press [STANDBY-ON Q].
2
Turn the TV on. Select the input to which the
unit is connected.
"Initial Setting" will automatically appear.
3
Select your desired language for the OSD using
[K \ L]. Then press [ENTER] to go to the next
step.
OSD Language
English
Áúëãàðñêè
Èesky
Nederlands
Français
Deutsch
Magyar
4
After finishing language setting, proceed to
"Clock" on page 61.
Note
• After "Initial Setting", if you need to unplug the mains cable,
make sure to turn off the power first and leave it in standby
mode for at least 1 minute before attempting to unplug.
Otherwise, it may cause data loss.
If you want to set each item of "Initial Setting" again, you can
set them at "General Setting".
• Refer to " OSD Language (Default: French)" on page 59.
• Refer to "Clock" on page 61.
20
EN

Selecting the TV Aspect Ratio

Use this feature to adjust the aspect ratio of the video source
which is different from your TV's ratio to fit your TV monitor
without distorting the picture.
1
In stop mode, press [SETUP]. Select "General
Setting" using [K \ L], then press [ENTER].
2
Select "Video" using [K \ L], then press
[ENTER].
3
Select "TV Aspect" using [K \ L], then press
[ENTER].
TV Aspect
Video Out
4 Select the desired option using [K \ L], then
press [ENTER].
TV Aspect
4:3 Letter Box
4:3 Pan & Scan
16:9 Wide
5
Press [SETUP] to exit.
Note
If you have a standard TV:
• Select "4:3 Letter Box" for a full width picture with black
bars at the top and bottom.
• Select "4:3 Pan & Scan" for a full height picture with both
sides trimmed.
If you have a wide screen TV:
• Select "16:9 Wide".