Error Messages - Pioneer AVIC-8100NEX Operation Manual

Appendix
Symptom
The smartphone was not
charged.

Error messages

When problems occur with this product, an error message appears on the display. Refer to the
table below to identify the problem, then take the suggested corrective action. If the error persists,
record the error message and contact your dealer or your nearest Pioneer service center.
Common
Message
AMP Error
TEMP
Product overheat. System will
be shut down automatically
in 1 minute. Restart the pro-
duct by ACC-Off/On may fix
this problem. If this message
keeps showing up, it is possi-
ble that some problem oc-
cured in the product.
Positioning is not possible
due to the hardware. Please
contact your dealer or Pioneer
service center.
No GPS antenna. Check con-
nection.
GPS antenna problem de-
tected. Contact dealer or ser-
vice center.
Calibration will start, but may
be inaccurate without speed
pulse.
Sensor error. Please contact
your dealer or Pioneer Service
Center.
Cause
Charging stopped because the tem-
perature of the smartphone rose
due to prolonged use of the smart-
phone during charging.
More battery power was consumed
than was gained from charging.
Cause
This product fails to operate or the
speaker connection is incorrect; the
protective circuit is activated.
The temperature of this product is
outside the normal operating range.
The temperature is too high for this
product to operate.
The location display is not possible
due to hardware failure.
GPS reception is lost.
GPS antenna lead is short-circuited. Contact your dealer or an authorized Pioneer
The speed pulse sensor is not con-
nected correctly.
An error has occurred with the sen-
sor.
Action
Disconnect the smartphone from the cable,
and wait until the smartphone cools down.
This problem may be resolved by stopping
any unnecessary services on the smartphone.
Action
Check the speaker connection. If the mes-
sage fails to disappear even after the engine
is switched off/on, contact your dealer or an
authorized Pioneer Service Station for assis-
tance.
Wait until this product returns to a tempera-
ture within the normal operating limits.
Follow the instructions displayed on the
screen. If this does not solve the problem,
contact your dealer or an authorized Pioneer
Station for assistance.
Contact your dealer or an authorized Pioneer
Station for assistance.
Check the antenna connection. If the mes-
sage fails to disappear even after the engine
is switched off/on, contact your dealer or an
authorized Pioneer Station for assistance.
Station for assistance.
Contact your dealer or an authorized Pioneer
Station for assistance.
Contact your dealer or an authorized Pioneer
Station for assistance.
Appendix
229
En