Programming Mode; Alarm Setting Mode - La Crosse Technology WT-2150A Instruction Manual

Programming Mode

1) Press the SET key to enter programming mode.
2) Time Zone: Press the MODE/+ key to change the time zone.
a) Default upon starting is Eastern (-5 GMT)
b) Can be set to –1 to –12 hour and GMT
c) The US map will highlight the time zones set within continental
United
d) States (Eastern (-5), Central (-6), Mountain (-7), Pacific (-8)) or
"GMT" will be displayed if set to GMT (0).
e) Press the SET key
3) DST: Press the MODE/+ key to switch Daylight Savings Time off or on. The
WWVB automatically corrects for DST; "DST" is to be set to "OFF" only in
areas that do not follow DST. Press the SET key.
4) Snooze: Press the MODE/+ key to select the desired snooze length from 0
to 59 minutes. Default is 10 minutes; 0 is no snooze (pressing the
SNOOZE bar turns off the alarm). Press the SET key.
5) Manual time setting: This is not necessary unless the alarm clock did not
pick up a signal upon start up and it is not favorable to wait overnight for
time set. If the time is manually set, be sure to set the time to the correct
AM/PM time.
a) Press the MODE/+ key to set the hour. Press the SET key.
b) Press the MODE/+ key to set the minute. Press the SET key.
c) Press the MODE/+ key to set the year. Press the SET key.
d) Press the MODE/+ key to set the month. Press the SET key.
e) Press the MODE/+ key to set the day. Press the SET key.
f) Press the MODE/+ key to set the weekday. Press the SET key.
g) Press the MODE/+ key to set 12- or 24-hour mode. Press the SET key.
6) Temperature Selection: Press the MODE/+ key to select °F (Fahrenheit)
or °C (Celsius). Press the SET key. The programming mode is complete.

Alarm Setting Mode

1) Press the ALM1 or ALM2 key for two seconds to enter the Alarm 1 or Alarm
2 setting mode.