Nylon Line Installation; Support Handle - Echo GT-225 Operator's Manual

GT-225

Nylon Line Installation

1. Shut engine OFF. Lay unit on the ground with head
assembly up.
2. Remove old nylon line through center recess of head.
3. Thread new lines through outside holes (A) in housing until
ends meet in center of recess.
Note: Insert cutting line ends to center of head recess to insure
easy removal of used lines.

Support Handle

Note: Label shows minimum spacing for Support Handle
location.
Note: Support Handle is pre-installed. Re-positioning and
tightening is all that is required.
1. Position Support Handle (A) in comfortable operating
position and tighten wing nut (B). The cutting attachment
should be 5 - 7.5 cm (2 - 3 in.) above the ground and as
level as possible.
X7722271506
© 02/2015 ECHO Inc.
A
MIN
SPACING
A
B
ASSEMBLY
15