Pride QUANTUM JAZZY SERIES Owner's Manual page 24

V . C O M F O R T A D J U S T M E N T S
11. Reinstall the ball detent pin into each seat tower.
12. Reinstall the shroud.
13. Reinstall the trapeze bars and secure with the
quick-release pins.
14. Reinstall the seat.
NOTE: Make sure the seat latch safety is flipped
down before using the power chair seat.
15. Plug the controller connector(s) into the electron-
ics tray.
Seat Position Adjustment
You can move the seat forward or rearward by chang-
ing the extrusion mounting position.
To change the seat position:
1. Turn off the power to the controller.
2. Unplug the controller connector(s) from the elec-
tronics tray.
3. Remove the seat from the power base.
4. Remove both extrusions from the bottom of the seat.
5. Reposition the extrusions on a different set of
mounting holes. You must move both extrusions
the same number of holes either forward or back-
wards. See figure 15.
6. Fasten the extrusions back onto the bottom of the seat.
7. Reinstall the seat.
8. Plug the controller connector(s) into the electron-
ics tray.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat,
you can adjust the seatback angle with the seatback
release lever. The lever is located on the right side of
the seat base.
To adjust the seatback angle:
1. Pull up on the seatback release lever.
2. Move the seatback down or up to the desired position.
3. Release the lever.
24
Figure 15. Seat Position Adjustment
www.pridemobility.com
SEAT MOUNTING HOLES
Quantum Jazzy 1420 Series