Pride QUANTUM JAZZY SERIES Owner's Manual page 22

To install the seat:
1. Set the trapeze bars to the desired height. To
change the trapeze bar height, see V. "Comfort
Adjustments."
2. Tilt the seat back and slide the rear extrusion onto
the rear trapeze bar. See figure 10.
3. Lower the front extrusion onto the front trapeze bar
until the seat locks into place.
4. Flip the seat latch safety down.
WARNING! Make sure the seat latch
safety is flipped down before using
your power chair.
Controller Installation
Depending on the various configurations and options
you have chosen for your power chair, it may have
been shipped without the controller module installed in
the armrest.
WARNING! Do not place the controller
harness so that it can be pinched in
the seat frame or power base frame.
1. Flip up either the right or left armrest.
2. On a contour seat, flip up the armrest and loosen
the setscrew. See figure 11.
3. Slide the controller into the armrest.
4. Tighten the setscrew(s) and lower the armrest.
5. Route the controller harness so that it cannot be
pinched in the seat hinge.
MANDATORY! Prevent controller harness
damage! Avoid routing the controller har-
ness on the outside of the armrest pad.
Route the harness under the armrest or
toward the inside of the armrest pad. Use
correct tie-down points for the controller
harness to prevent the harness from get-
ting caught in the drive tyres, pinched in
the seat frame, or damaged when passing
through doorways.
6. Remove the rear lid to expose the electronics tray.
7. Plug the controller connector into the electronics
tray. See figure 7.
8. Secure the controller harness to the armrest
receiver with one or more wire ties. See figure 12.
22
I V . A S S E M B L Y
Figure 11. Controller Installation (Underside of Armrest)
Figure 12. Controller Harness Routing on a Contour
Seat
www.pridemobility.com
CONTROLLER BRACKET
SETSCREW
Quantum Jazzy 1420 Series