Immobilizerdevice Enabled Indicator Led; Operation - PIAGGIO Beverly 400 I.E Maintenance Instructions Manual

Immobilizerdevice enabled indicator led (01_15)

Activation of the "PIAGGIO IMMOBILIZER" system is signalled by a flashing warning
light "C" (see section "Analogue instrument panel").
In order to reduce battery discharge, the indicator LED turns off automatically after 48
hours of uninterrupted functioning.
Should the system fail, different LED flashing patterns will be provided by an Author-
ised Piaggio-Gilera Service Centre with information on the type of fault detected.
01_15

Operation (01_16)

Every time the starter key is removed in the "OFF" or "LOCK" position, the safety
system activates the immobilizer system. Turning the key to "ON" disables the engine
lock, provided that the safety system recognises the code transmitted by the key. If
the code is not recognised, turn the key first to "OFF" and then to "ON"; if the lock
cannot be disabled, try with the other key supplied (red-coloured). If the engine cannot
be started, contact an Authorised Piaggio Service Centre, which is provided with
the electronic equipment required to detect and repair the system. The immobiliser is
also activated in the engine is switched off with the RUN OFF switch. This happens
even if the starter key is in position "ON".
01_16 When additional keys are required, please note that data storage (up to 3 keys max.)
must be done on all keys, both new ones and existing ones. Take the key with the red
grip and all the black keys supplied to an Authorised Piaggio Service Centre. The
codes of keys not submitted for the new storage procedure are deleted from the
memory. Any lost keys will therefore not be enabled to start the engine.
WARNING
EACH KEY HAS ITS OWN AND UNIQUE CODE, WHICH MUST BE STORED BY
THE SYSTEM CONTROL UNIT.
14