Pride Mobility PATHRIDER 140 XL Owner's Manual page 34

V I . C O M F O R T A D J U S T M E N T S
POSITIONING BELT (OPTIONAL)
Your scooter seat may be equipped with an auto-type
positioning belt that can be adjusted for operator com-
fort. The positioning belt is designed to help support
the operator so that he or she does not slide down or
forward in the seat. The positioning belt is not
designed for use as a restraining device.
To install the positioning belt (if required):
1. Remove the seat from your scooter.
2. Place the seat upside down so that you can see the
bottom of the seat base. See figure 18.
3. Use a wrench to remove the two back bolts on the
outermost part of the rear seat.
4. Insert the bolt through the appropriate ends of the
positioning belt and then reinstall the bolts and
belt back into the seat bottom.
5. Tighten the bolts.
To adjust the positioning belt for operator comfort:
1. Insert the metal tab on the right side of the belt into the plastic housing on the opposite strap until you
hear a "click." See figure 20.
2. Pull the strap on the right side of the belt until it is secure, but not so tight as to cause discomfort.
MANDATORY! Make sure the positioning belt is properly secured to the scooter and is
adjusted for operator comfort before each use.
MANDATORY! Inspect the positioning belt for loose or damaged parts before each use of
the scooter. If you discover a problem, contact your authorised Pride Provider for main-
tenance and repair.
34
Figure 20. Positioning Belt
www.pridemobility.com Pathrider 140 XL