Chapter 4 User Preferences & Miscellaneous
Digital Scanner Options
Introduction
If desired, program the digital scanner to perform various functions, or activate different features. This chapter
describes each user preference feature and provides the programming bar codes necessary for selecting these
features.
The digital scanner ships with the settings shown in
Parameters
for all host device and miscellaneous defaults). If the default values suit requirements, programming is
not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in non-volatile
memory and are preserved even when the digital scanner is powered down.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where the bar code can be seen clearly, and
bars and/or spaces are not merging.
If not using a USB cable or Synapse cable, select a host type (see each host chapter for specific host information)
after the power-up beeps sound. This is only necessary upon the first power-up when connected to a new host.
To return all features to default values, scan the
bar code menus, default values are indicated with asterisks (
Set Default Parameter on page
*
*
High Volume
Indicates Default
Table 4-1 on page 4-2
(also see
*
).
Feature/Option
(00h)
Option Hex Value for
programming via SSI
command
Appendix A, Standard Default
4-4. Throughout the programming