switched off. You should then switch on the TV to
enable recording feature. Otherwise, recording feature
will not be available.
•
After you have selected a programme in EPG menu,
press the OK button and and Options screen will
be displayed. Select "Record" option and press the
OK button. After this operation, a recording becomes
set to the selected programme.
•
To cancel an already set recording, highlight that
programme and press the OK button and select
the option "Delete Rec. Timer". The recording will
be cancelled.
Note: You cannot switch to any other channel or
source while there is an active recording on the
current channel.
Set Timer / Delete Timer
After you have selected a programme in EPG menu,
press the OK button and and Options screen will
be displayed. Select "Set Timer on Event" option
and press OK button. You can set a timer for future
programmes.
To cancel an already set reminder, highlight that
programme and press the OK button. Then select
"Delete Timer" option. The timer will be cancelled.
Note: It is not possible to record or set timer for two or
more individual events at the same time interval.
First Time Installation
IMPORTANT: Ensure that the aerial or cable is
connected and a Common Interface module is not
inserted before switching on the TV for the fi rst
time installation.
•
When the TV is operated for the fi rst time, installation
wizard will guide you through the process. First,
language selection screen will be displayed:
•
Use "
" or " " buttons to select your language
and press OK button to set selected language and
continue.
•
After selecting the language, "
be displayed, requiring you to set Country,Teletext
Language and Scan Encrypted options.
03_MB60_[GB]_ypbpr_1910UK_PVR_IDTV_TC_NICKEL16_32915WLED_10073970_50192683.indd 83
03_MB60_[GB]_ypbpr_1910UK_PVR_IDTV_TC_NICKEL16_32915WLED_10073970_50192683.indd 83
•
By pressing "
you want to set and press " " button to highlight
Teletext Language option. Use " " or " " button
to select desired Teletext Language.
•
Press "
option. Scan Encrypted will be then highlighted.
You can set Scan Encrypted as Yes if you want to
scan coded stations.Afterwards select the desired
Teletext Language.
•
Press
and the following message will be displayed on the
screen:
To select the "Yes" or "No" option, highlight the item by
using " " or " " buttons and press OK button.
Afterwards, the following OSD will be displayed on
the screen:
If you select CABLE option, the following screen will
be displayed:
Welcome!" screen will
You can select frequency ranges from this screen. For
highlighting lines you see, use " " or " " button. You
can enter the frequency range manually by using the
English - 83 -
" or " " button, select the country
" button after setting Teletext Language
OK button on the remote control to continue
06.06.2011 13:52:33
06.06.2011 13:52:33