Sound Setting - Panasonic CQ-HX2083U Operating Instructions Manual

Troubleshooting
E
N
G
L
I
S
❐ CD/MP3/WMA (Continued)
H
31
Trouble
Mounting angle is over 30o.
➡Adjust mounting angle to less than 30x.
Sound skips due to vi-
bration.
Instable mounting.
➡Mount the unit securely with the mounting parts, referring to the
section on installation.
≥ Disc is defective.
≥ Mechanical trouble.
➡Press [OPEN] to open the panel and press [<] (eject). If normal op-
Disc is not ejected.
eration is not restored, call the store where you purchased the unit
or the nearest Servicenter to ask for repairs.
≥ Disc is dirty.
≥ Disc has scratches.
CD text is not displayed
➡Clean disc, referring to the section on "Notes on CD/CD Media
normally.
(CD-ROM, CD-R, CD-RW)".
The first track of a mix mode disc was reproduced. (Mix mode is a for-
Time is counted but no mat in which data except music is recorded on the first track and music
sound comes out. data is recorded on other than the first track in a session.)
➡Play back music data recorded on other than the first track.
The disc does not conform to any of the file systems supported by this
player.
➡Insert a disc that conforms to the file systems (ISO 9660 Level 1,
Level 2, Joliet, Romeo or Apple Extension to ISO 9660).
No playback.
The MP3 file is missing the ".mp3" file name extension.
➡Make sure to add the ".mp3" extension to each MP3 file name.
The WMA file is missing the ".wma" file name extension.
➡Make sure to add the ".wma" extension to each WMA file name.
The folders and files recorded on the disc are layered too much.
It takes too long for
➡As checking of files takes longer in this case, do not record any un-
playback to start.
necessary folders or files other than MP3/WMA on the disc.
58
CQ-HX2083U
(Continued)
Cause/Step
❐ CD/MP3/WMA (Continued)
Trouble
➡The recording quality differs depending on the encoding software
used, and on settings such as the bit rate. Set the bit rate within the
range specified in the specifications chart (page 75).
The suggested bit rate for MP3 is "128 kbps or more", "Fixed."
Poor recording quality,
For WMA, the suggested rate is" 64 kbps or more", "Fixed".
sound skipping.
High-speed writing was executed when MP3/WMA data was recorded
on the disc.
➡Decrease writing speed as low as possible.
Files or folders are not recorded in the desired playback order.
➡Some writing software lets you specify the recording order by
Files are not played in
adding a prefix in the range of "01"j"99", etc. to the file name.
the desired order.
For details, refer to the user manual of your writing software.
The disc does not conform to the file systems supported by this player.
➡Insert a disc that conforms to the file systems (ISO 9660 Level 1,
Folder/file name is not Level 2, Joliet, Romeo or Apple Extension to ISO 9660).
displayed correctly.
➡There may be a problem with your writing software or CD recorder
(CD-R/RW drive). For details, refer to the user manual of your writ-
ing software.
You ran the file in fast forward or fast reverse during playback or turned
off the ignition switch of the car during playback.
➡Playing another file will return the file playing time to normal.
File playing time is not
displayed correctly.
You played a VBR (Variable Bit Rate) format file.
➡The file playing time of VBR (Variable Bit Rate) format MP3 file is
sometimes displayed incorrectly.

❐ Sound Setting

Trouble
Left and right balance, or front and rear balance is off on one side.
No sound from left, ➡Adjust balance/fader setting as appropriate.
right, front or rear
speakers. Cables are not correctly connected.
➡Connect the cables correctly.
Left and right sounds
The speaker wires are reversed between right and left.
are reversed in stereo
➡Connect the speaker wires to the correct ones.
listening.
E
N
G
L
I
S
H
32
Cause/Step
Cause/Step
59
CQ-HX2083U