Initial Set Up Procedures - Raymarine E70085 Dragonfly Operation Manual

1. Rotary — use this to navigate through menu options and
adjust the range in the Chart application and the Sonar /
DownVision applications if set to manual range, or to cycle
through the View switcher options.
2. Joystick — use this to move the cursor position in
applications, pan up, down, left and right in the chart
applications, navigate up and down through menu options or
to cycle through the View switcher options.
3. OK button — push the end of the joystick to open menus,
or context menus whilst in an application or to confirm a
selection.
Getting started

6.3 Initial set up procedures

Once your display has been installed and commissioned, it is
recommended that you go through the initial startup wizard and
1
tutorial.
Startup wizard
1
2
When you power-up the display for the first time or after a system
reset, the Startup Wizard is displayed a few seconds after the
Limitations On Use screen has been acknowledged. The Startup
Wizard guides you through the following initial settings:
1. Language selection.
3
2. Configure units.
3. Finish / Start tutorial.
Note: These settings can also be set at any time using the
D12180-1
System Settings menu accessible from the Tools & Settings
page.
Additional tasks
In addition to the settings covered by the Wizard, it is also
recommended that the following tasks are completed:
• Set your date and time preferences.
• Set your transducer depth offset.
• Familiarize yourself with the product using Simulator Mode.
Setting time and date preferences
1. Select Tools & Settings from the View switcher.
2. Select System Settings.
3. Select Time and Date Set-up.
4. Use the Date Format, Time Format, and Local Time: menu
items to set your time and date preferences.
Simulator mode
The Simulator mode enables you to practice operating your
display without data from the GPS receiver or transducer.
The simulator mode is switched on / off in the System Settings
menu.
Note: Raymarine recommends that you do NOT use the
simulator mode whilst navigating.
Note: The simulator will NOT display any real data. This
includes safety messages.
Enabling and disabling simulator mode
You can enable and disable simulator mode by following the
steps below.
1. Select Tools & Settings from the View switcher.
2. Select System Settings.
3. Select Simulator:.
4. Select On to turn simulator mode on, or
5. Select Off to turn simulator mode off.
2
3
D12783-1
35