Sharp LC-32D44E Service Manual page 17

1) Check the connection between TV set and PC, sending a wrong command, as for example: "aaa". TV set returns an "ERR" label as an syntaxis
ERROR (Not correct order or sequence).
2) Send the command "DWMD" to enter TV set in Download Mode. The TV set answer sending same symbol continuosly. If this symbol character
doesn't appear, please don't worry and pass to next step.
3) Close this connection and open "P55_115200bps" connection clicking over the "P55_115200bps" that you can find in "START\All pro-
grams\Accessories\ Communications\HyperTerminal\HyperTerminal" folder.
4) Using "Transfer\Send file..." menu, select desired file (.bin format) and the transmission protocol (Xmodem) as show below.
5) After press "Send" button the updating process starts as follows:
6) When flash update process finishes, the "Flash Programming Complete" label appears in the screen, the device automatically go to switch off,
and in a few seconds go to switch on again.
VERY IMPORTANT NOTE:
During the updating time, please don't use the PC for other purpouses, in order to abolish communication problems between TV set and
PC. If TV set was not updated properly, the TV won't have the software to startup again, and you must follow the "I2C method" to update
another time the TV set.
LC32D44E/S/RU-BK/GY (1st Eddition)
3 – 3