Preparing The Sprayer For Each Use - North Star 2851701 Owner's Manual

Operation – Preparing the Sprayer for Each Use
If the sprayer has been used previously, it must be prepared BEFORE EACH SUBSEQUENT USE.
Read instructions below carefully for inspecting and preparing the sprayer.
Damaged or clogged equipment could result in leaks or uncontrolled spray.
Leaks could result in injury to the operator or bystanders from chemical exposure,
or cause damage to the environment.
Important safety rules:

Power off. Make sure all power is OFF before cleaning, inspecting, or servicing the sprayer.

Guards / shields. Make sure all guards and shields are replaced after servicing the sprayer.

Replacement parts. If a part needs replacement, only use parts that meet the manufacturer's
specifications. Replacement parts that do not meet specifications may result in a safety hazard or poor
operation of the sprayer.
1. Ensure sprayer Ensure the sprayer is securely attached to the vehicle.
attached
2. Ensure tank Ensure the sprayer has been thoroughly flushed and drained of all residual chemical
empty from prior uses.
3. Clean suction Clean the suction strainer of any chemical residue.
It is important to clean the suction strainer before each use to ensure it is not clogged and to
strainer
prevent residual chemical from contaminating sprayer contents.
IMPORTANT: The strainer must be accessed by reaching into the tank, so the tank must
be empty to avoid immersing your hand in chemicals.
Inspect and test the sprayer thoroughly:
4. Inspect & repair
a) Inspect hoses for exposed mesh and holes. Replace all worn or damaged hoses.
b) Inspect tank and fittings for cracks and leaks. Replace all damaged fittings with
c) Check to be sure retaining nut on gun nozzle is tight.
d) Check to be sure all other nuts, bolts, and screws are tight.
e) Check wheels and tires, if equipped. Make sure wheel lugs are tight and tires are
f)
IMPORTANT: After any repair work has been done, ALWAYS test for leaks with water
one final time before using.
WARNING
a) Open fill cap on top of tank.
b) USING RUBBER GLOVES, reach into the tank and pull the suction strainer off the
end of the suction tube. (See figure below.)
c) Run the suction strainer under fresh water to remove debris.
d) Replace the suction strainer onto the end of the suction tube.
Fill cap
Suction
strainer
(Inside tank)
original NorthStar parts.
inflated.
Partially fill tank with plain water and spray to test for leaks. Repair as needed.
25