Chapter 2 — Installation
Package Contents
The package contains the following:
Digital Video Recorder
Power Adaptor and Power Cord
User's Manual (This Document)
RAS Software CD and User's Manual
Infrared Remote Control
Required Installation Tools
No special tools are required to install the DVR. Refer to the installation manuals for the other items that make up part
of your system.
Video Input
Network Port
Your DVR can be used with either NTSC or PAL equipment.
NOTE: You cannot mix NTSC and PAL equipment. For example you cannot use a PAL camera and an NTSC
monitor.
Video Input
Alarm Input/Output
NOTE: To make connections on the Alarm Connector Strip, press and hold the button
and insert the wire in the hole below the button. After releasing the button, tug gently
on the wire to make certain it is connected. To disconnect a wire, press and hold the
button above the wire and pull out the wire.
Figure 2: 8-Channel DVR rear panel.
Alarm Input/Output
Video Out
Factory Reset Switch
Connect the coaxial cables from the video sources to the BNC Video In connectors.
RS485 Port
RS232 Port
Power Cord Connector
Digital Video Recorder
3