Sony SAL20F28 Service Manual page 15

HELP04
1. Attach the main flexible unit to the rear light interception tube with two screws as shown in the figure.
2. Affix the main flexible unit to flexible set tape as shown in the figure.
3. Bend the main flexible unit to inside of rear light interception tube, fix with the flexible set tape in the arrow direction.
Note:
When handling the main flexible unit, take care the static electricity.
Main Flexible Unit
Ground Spring
Rear Light Shield Barrel
HELP05
Adhesive bond (B-40): J-6082-614-A
1. Hook the main spring to the hook of rear light shield barrel and the hook of preset ring.
2. Install the rear light shield barrel to the lens mount riveting block, apply the adhesive bond (B-40) to the screwed portions of screws,
and tighten screws.
3. Install the ground spring to the rear light barrel and then the signal board.
Note:
Be careful not to tighten screws too strongly.
Confirm that the preset ring moves smoothly.
Main Flexible Unit
Apply the adhesive bond(B-40)
Lens Mount
Riveting Block
Preset Ring
SAL20F28 (2.0/28) (20mm F2.8)
Two Screws
Flexible Set Tape
Main Flexible Unit
Ground Spring
Apply the adhesive bond(B-40)
Rear Light Shield Barrel
Main Spring
Rear Light Interception Tube
HELP