Specifications - Kustom KPM8420 Owner's Manual

Model
Output Power
Frequency Response
Total Harmonic Distortion
Hum & Noise
System Gain
Crosstalk
Input Channel Equalization
Master Equalization
Digital Effects
Phantom Power
Footswitch
Power Requirements
Dimensions
KPM8420

Specifications

KPM8420 8 Channel Dual Powered Mixer
200W per channel 4 Ohms @ 5% THD
180W per channel 4 Ohms @ 0.4% THD
Actual response is tailored to speaker cabinet for
20HZ-20kHz
accurate acoustical response.
Measured at 1VRMS (0dBv) at record output, effects
Less than 0.4%
send, preamp output, or Main output.
-115dB Mic Input, Rs=150 ohm, 20-20kHz
-55dB Residual Noise, all level controls 0% (minimum)
-45dB Nominal System Noise, all level controls at 50%
All Measurements made at 1kHz
90 dB Mic to Power Amp (Ch 1 - Ch8) Pad Off
77dB Mic to Power Amp (Ch 1 - Ch8) Pad On
72dB Line to Power Amp (Ch 1 - Ch8) Pad Off
60dB Line to Power Amp (Ch 1 - Ch8) Pad On
36dB Playback to Power Amp
50dB Mic to Main out, Pad On
50dB Mic to Monitor out, Pad On
50dB Mic to Record out, Pad On
70dB Channel to Channel, 1kHz
Special curve that adjusts Bass, Mid, and Treble frequencies
100 to 10kHz, 7 Band, 1 Octave Graphic, all ±12dB
Two 24 bit DSP modules, 8 effects per module.
Module 1:
Small room, Large room, small hall, large hall, chorus, chorus reverb, slapback, echo
Module 2:
Short room, Med room, small hall, Med hall, chorus, chorus reverb, chorus hall, short delay
+40V Applied to all Mic inputs when active
Digital effects On/Off and Channel ON/OFF (playback remains active)
Recommended: KUSTOM model KAC-FS-202 (dual switch with LEDs)
USA/Canada 120VAC/60Hz, 300W nominal
Europe 230VAC/50Hz, 300W nominal
UK 230VAC/50Hz, 300W nominal
Australia 240VAC/50Hz, 300W nominal
Japan 100VAC/50-60Hz, 300W nominal
mm/kg 292 (Height) x 495 (Width) x 305 (Depth), 15.6kg
Inches/Pounds 11.5 (Height) x 19 (Width) x 12.1 (Depth), 34.4 lbs
12