Adjusting Feed Dog Height - Janome Magnolia 7325 Service Manual

• The standard height of the feed dog should be 0.75-0.85 mm above the needle plate
when the feed dog is at its highest position.
<To adjust>
Select the straight stitch (
Lower the presser foot. Turn the handwheel to bring the feed dog to its heighest position.
Remove the base cover (see page 2).
Loosen the setscrew (A) and nut.
Turn the adjusting screw to set the feed dog height to 0.75 to 0.85 mm.
Tighten the nut and setscrew (A).
Attach the base cover.

Adjusting Feed Dog Height

) and set the stitch width at "4".
Presser foot
Feed dog
Setscrew (A)
Nut
13
0.75 to 0.85mm
Needle plate
To raise
To lower
Adjusting screw