Pfaff 3371-10 series Instruction Manual page 58

Input
Gruppe
58
Group Parameter Description
Parameter Bedeutung
000 006 Reversing after thread trimming
Reverse position [°]
With this parameter it is possible to
switch the automatic reversing func-
tion after thread trimming on or off. If
the reversing function is switched on,
the reverse position can be set by tur-
ning the balance wheel. The access
code is necessary for this adjustment.
007 Starting point = scale reference
point
With this parameter it is possible to
choose whether the scale reference
point is the starting point (ON) or the
zero point (OFF).
008 Speed for the "winding" function
This parameter is used to fix the
speed for the winding operation.
009 Via zero point to starting point after
end of sequence
With this parameter it is possible to
choose that, after the end of the
sequence, the X-, Y-drive moves to the
seam starting point via the reference
initiators.
010 Via zero point to starting point after
number of program cycles Number
of program cycles
With this parameter it is possible to
choose that, after a certain number of
program cycles, the X-, Y-drive moves
to the seam starting point via the refe-
rence initiators.
011 Pedal mode
Switchover between level mode (0)
and flip flop mode (1)
012 Needle or balance wheel position
in degrees
Setting Set value
range
ON - OFF ON
0 - 14 11
ON - OFF OFF
200 - 2500 1500
ON - OFF OFF
ON - OFF OFF
1 - 100
0 - 1 0
0 - 360 11