Table of Contents
Advertisement
Warning and Error Messages
When the unit generates a warning, the OSD of the record and playback screen shows an error number and an error message.
When an operational malfunction occurs in the unit, an error number will flash on the OSD of the record and playback screen.
Error Information
The POWER lamp, the P2 card access lamp and a beep sound notify the operator of a malfunction that is detected during
powering up or operation.
The beep notification is enabled when the SETUP - BASIC - BEEP menu setting is set to ON (➝ Setup Menu "BASIC" - "BEEP"
page 61).
*
1
Monitor display
Warning message
*
2
E-37, 38
System error
2
*
E-30
Incorrect P2 card removal
*
2
E-31
Recording error
E-BA
Displayed during a
The battery is depleted.
*
2
preset time period
2
*
E-21
Recording error
*
2
E-80, 81, 83, 84
Connection error
One remaining
battery capacity
Battery nearly empty
indicator blinks
*
1
Same range of destination output set in the SETUP - DISPLAY - OSD OUTPUT menu setting.
2
*
For details on display location, refer to the OSD display (➝ Setup Menu "DISPLAY" - "OSD OUTPUT" page 67). The error
number and "AUTO OFF" are alternately displayed.
POWER lamp
Beep sound
Blinks 4 time
Repeated
per second
rapidly
Blinks 4 time
Repeated
per second
rapidly
Blinks 4 times
Repeated
per second
rapidly
Blinks 1 time
Repeated
per second
rapidly
Blinks 4 time
Repeated
per second
rapidly
Blinks 4 time
Repeated
per second
rapidly
Blinks 1 time
None
per second
For Long and Trouble-Free Operation: Warning and Error Messages
Description
P2 microprocessor or
To continue operation,
control failure. Operation
turn the power off and
stops.
then back on again.
A P2 card was removed
Turn the unit off. Repair
during access and an
any clips on the removed
error occurred in inner
P2 card that are
memory.
corrupted.
Turn the power off, then
turn it on again and try
Recorded data is
again. Replace a P2 card
corrupted.
that does not enable
normal recording.
The battery is depleted.
Recording and playback
Replace the battery with a
stop. The unit is turned off
freshly charged battery.
automatically when the
voltage drops further.
Turn the power off , then
turn it on again and try
again. Replace a P2 card
that does not enable
A recording error has
normal recording. Stop
occurred.
(STOP) and start
Stop recording.
playback to clear the
error, displayed error
message and beep
sound.
A malfunction has
Turn the power off and
occurred in the 3D REC/
check the connections
PB mode or SYNC PB
and other factors.
mode system.
The battery is near
Replace the battery as
depletion.
necessary.
Countermeasure
83
Hide quick links:
Advertisement
Table of Contents
