Toshiba 15SZ2E Service Manual page 16

• Under some reception conditions, fine tuning may be necessary to improve the picture quality. In such cases, adjust the
manual fine tuning (MFT).
• If the signal frequency is unstable due to environmental conditions, use auto fine tuning.
Skip Function
If you set "SKIP ON" for unnecessary position numbers, these
will be skipped when selecting channels using CH s/t.
Example : Skipping Channel 13
1
Select Position 13 using the same method for select-
ing Position 12 (above).
2
Press MENU and ; –/+ to call up the "SET UP" menu
D7 . Press CH s/t and select "SKIP".
Press ; –/+ to switch the "SKIP" setting from "OFF"
to "ON". This completes the setting for skipping Posi-
tion 13.
Note:
• When "SKIP" is ON, the Position number is prefixed by
"*".
Example: *13. To confirm this, select Position 13 using
the -/-- and 0~9 buttons.
• If you want to restore a skipped position number,
select it using the -/-- and 0~9 buttons then switch the
"SKIP" setting to "OFF" as in step 2 above.
Manual fine tuning (MFT)
1
Press MENU and ; –/+ to call up the "TUNING" menu
D8 .
2
Press CH s/t and select "MFT". Press ; –/+ to start
fine tuning. Pressing "-" fine tunes to a lower frequency
while pressing "+" fine tunes to a higher frequency.
Auto fine tuning (AFT)
1
Press MENU and ; –/+ to call up the "TUNING" menu
D8 .
2
Press CH s/t and select "AFT". Press ; –/+ to switch
it to "ON". This completes the setting.
Notes:
• When you operate MFT, AFT is switched OFF
automatically. If you switch on AFT after fine tuning
with MFT, MFT may be cancelled.
• AFT may be set independently for each Position.
– 16 –