Battery Installation - Power Wheels V3298 TOT ROD Toy Story 3 Owner's Manual With Assembly Instructions

IMPORTANT! Use only a Power Wheels
(4.0 Amp/Hr) rechargeable battery. Use of any other
battery will damage your vehicle.
LOCKED
1
• Locate the lock fasteners on the front edge of the seat.
• Using a slotted screwdriver, turn both lock fasteners ¼
turn to the unlocked position
2
• Grasp under the front of the seat and lift firmly to
remove it.
V3298pr-0920

BATTERY INSTALLATION

® 6 volt
UNLOCKED
.
Battery Connector
3
• Remove the #8-18 x ⅞ " screw from the battery
retainer. Lift to remove the battery retainer from
the vehicle.
• Place the Power Wheels
in the battery compartment. Make sure the battery
connector extends toward the rear of the vehicle.
• Replace the battery retainer over the battery. Insert the
#8-18 x ⅞ " screw through the battery retainer and into
the vehicle. Tighten the screw.
4
• Plug the battery connector into the motor
harness connector.
Note: If the battery connector will not plug into the
motor harness connector, turn it over and try again!
Do not force the battery connector into the motor
harness connector.
• Re-assemble the seat to the vehicle. Using a slotted
screwdiver, turn the lock fastener ¼ turn to the locked
position .
IMPORTANT! Always remember to keep the lock
fasteners locked at all times to prevent children from
accessing the battery.
12
Battery Retainer
®
6 Volt (4.0 Amp/Hr.) battery