Kenwood KRC-31Y Service Manual page 5

BALANCE/FADER/BASS/TREBLE : CENTER
T. ADV/METAL/DOLBY NR/AUTO : OFF
No. Item Input
Settings
FM Section
98.1MHz
0 dev
1 SD
35dBµ
(ANT input)
AM Section
990kHz
0% mod
(1) SD
35dBµ
(ANT input)
Cassette Deck Section
TCC-153
1 AZIMUTH
10kHz
TEST MODE : ON While holding the "FM" key and preset "6" key, reset the unit.
TEST MODE : OFF Reset the unit.
ADJUSTMENT
Output Receiver
Settings Settings
TEST MODE : ON
– FM
98.1MHz
TEST MODE : ON
– AM
990kHz
SP OUT TAPE PLAY
(a) AZIMUTH
FWD
REV
KRC-31Y/36/366L/37/Y
/391/394/Y/466R/4904Y
Alignment
Points
While holding preset "1" key,
press and hold preset "6" key
for a few seconds.
Preset "1" key, and "ADJ OK" is good.
preset "6" key "ADJ NG" is not good.
(7 seg model :
"1111" is good.
"0000" is not good.)
While holding preset "1" key,
press and hold preset "6" key
for a few seconds.
Preset "1" key, and "ADJ OK" is good.
preset "6" key "ADJ NG" is not good.
(7 seg model :
"1111" is good.
"0000" is not good.)
Adjust so that output level in
Head azimuth screw
playing "FWD" and "REV"
(FWD/REV)
becomes maximum each.
PANEL FRONT
Align For Fig.
(a)
5