Samsung 450 User Manual page 81

Connecting a VCR
Connecting to Video
VCR Rear Panel
Audio Cable
(Not supplied)
Video Cable (Not supplied)
Antenna Cable (Not supplied)
When connecting a VCR, match the color of the connection terminal to the cable.
If you have a "mono" (non-stereo) VCR, use a Y-connector (not supplied) to hook up to the right and left audio input jacks of the
TV. If your VCR is stereo, you must connect two cables.
Each VCR has a different back panel configuration.
When connecting to AV IN 1, the color of the AV IN 1 [Y/VIDEO] jack (Green) does not match the color of the video cable (Yellow).
Connecting to S-Video
VCR Rear Panel
Antenna Cable (Not supplied)
1 2
Audio Cable (Not supplied)
S-Video Cable (Not supplied)
When connecting a VCR, match the color of the connection terminal to the cable.
Each VCR has a different back panel configuration
TV Rear Panel
TV Side Panel
2 1
TV Rear Panel
TV Side Panel
English - 5
Unplug the cable or antenna from
1
the back of the TV.
Connect the cable or antenna to the
2
ANT IN terminal on the back of the
VCR.
Connect an Antenna Cable between
3
the ANT OUT terminal on the VCR
and the ANT IN terminal on the TV.
Connect a Video Cable between the
4
VIDEO OUT jack on the VCR and
the AV IN 1 [Y/VIDEO] or AV IN 2
[VIDEO] jack on the TV.
Connect Audio cables between the
5
AV IN 1 [R-AUDIO-L] jacks on the
TV and the AUDIO OUT jacks on
the VCR.
Press the SOURCE button on the
6
remote control until you see the VCR
signal (see "To Select the Source"
on page 10).
To begin, follow steps 1–3 in the
1
previous section to connect the
antenna or cable to your VCR and
your TV.
Connect a S-Video cable between
2
the [S-VIDEO] jack on the TV and
the S-VIDEO OUT jack on the VCR.
Connect Audio cables between the
3
AV IN 2 [R-AUDIO-L] jacks on the
TV and the AUDIO OUT jacks on
the VCR.
Press the SOURCE button on the
4
remote control until you see the VCR
signal (see "To Select the Source"
on page 10).