Table of Contents
Advertisement
Quick Start
The abbreviated procedures in this Quick Start
section enable you to connect and operate your
KPS 28c system quickly to enjoy its basic fea-
tures. To access the full array of available fea-
tures for the KPS 28c, please read the entire
owner's reference manual. Numbers in paren-
theses refer to Figure 1 on page 5, Figure 2 on
page 7, and Figure 3 on page 9.
INPUT AND OUTPUT CONNEC-
TIONS
IMPORTANT
Make sure all components and power sources
are off before connecting inputs and outputs.
When switching
between active
sources,
always lower the volume to off or mute the out-
put. This ensures that the next source played
does not damage your system with a high out-
put transient.
Analog Output Connections
Connect the Krell CAST cables from the left and
right Krell CAST 4-pin outputs (13) on the KPS
28c back panel to your CAST-enabled preampli-
fier.
For balanced or single-ended operation,
connect the interconnect cables from either the
left and right balanced (14) or the single-ended
(15) outputs on the KPS 28c back panel to either
the balanced or the single-ended inputs on your
preamplifier. (The remaining outputs can be con-
nected to another preamplifier in a different sys-
tem .)
Note
You can set up your KPS 28c to play a musi-
cal selection in three different areas. Connect
the CAST output to a CAST-enabled system in
one listening area, the balanced output to a
system in a second listening area, and the sin-
gle-ended output to a system in a third listen-
ing area. The musical selection will play simul-
taneously in all three areas.
Digital Output Connections
Connect the cables from the optics output (16)
coaxial output (17) on the KPS 28c back panel
your digital recorder or the digital input on your
preamplifier.
POWER ON
1. Connect the AC power cord to the IEC power
connector (20), then connect the AC power
cord to the wall socket. The KPS 28c is in the
stand-by mode. The red stand-by LED (3)
illuminates.
2.
Press the power button (4) or pwr key (22)
switch the KPS 28c from the stand-by to the
operational mode. The blue power LED (5)
illuminates and you hear a click. The KPS
28c is ready to play music.
TO PLAY A COMPACT DISC
1. Use the open/close button (2) or open key
(23) to open the compact disc transport (1).
2. Place a compact disc on the transport.
3. Use the open/close button (2) or open key
(23) to close the compact disc transport (1).
Playback automatically begins from the first
track. Adjust the system volume through your
preamplifier or amplifier.
4.
Press the stop button (11) or key (28) to
compact disc playback.
Note
You can also begin track playback by pressing
the play button (12) or key (29), or select a track
using the direct track access keypad (26), the
track forward and back buttons (8, 9) or keys (30)
or the search forward and back keys (31).
4
Krell Playback System 28c
Advertisement
Table of Contents
