Erase Track "Erstrack" - Erasing A Track - Korg D4 Owner's Manual

example, select "1." Then press the CURSOR [
5 Set the "In Time" and "Out Time."
Use the [VALUE] dial to specify each locate point.
After you've specified the locate points, press the
CURSOR [ ] key. (Refer to "Copying a track")
You can press the [PLAY] key to hear approximately two sec-
onds of playback starting at the selected time location.
6 Execute the editing operation.
When the display asks "Ins OK?," press the CURSOR
[ ] key to execute the operation. When the blank space
has been inserted, the display will indicate "Finish!"
7 Press the [PLAY] key to listen to the play back, and
verify that the operation occurred as you intended.
You can press the [UNDO] key to return to the state prior to
executing this operation. (→p.26)
Erase Track "ErsTrack" — erasing a track
This operation erases any recorded information from the
specified region (In–Out) of a recorded track. When you erase
the region, the data in that region will change to silence.
In Out
Blank
As an example, here's how to erase the In–Out region of
track 1.
1 Store the In and Out time locations in the [IN
(LOC1)] key and [OUT (LOC2)] key.
2 Select "TRK EDIT" mode.
Set the [MODE] knob to "TRK EDIT."
] key.
DestTrk
DestTrk
3 Select the Erase operation.
Use the [VALUE] dial to select "ErsTrack," and press
the CURSOR [ ] key.
4 Select "EraseTo" (track number from which you
want to erase data).
Use the [VALUE] dial to select the number of the track
from which you want to erase data. For this example,
select "1." Then press the CURSOR [
5 Specify the InTime ("In" time location) and OutTime.
Use the [VALUE] dial to make your selections (see "Copy
Track"). Then press the CURSOR [
time locations you specified in Step 1, select "LOC 1 (IN)"
as the "In" time and "LOC 2 (OUT)" as the "Out" time.
You can press the [IN (LOC1)] or [OUT (LOC2)] key at this
point to modify the selected time. You can also press the
[PLAY] key to audition the playback for approximately two
seconds starting at the selected time. Modifying the time
here will not affect the time that is registered in the key.
6 Execute the operation.
When the display asks "Ers OK?," press the CURSOR
[ ] key to execute the operation. When the data has
been erased, the display will indicate "Finish!"
7 Press the [PLAY] key to listen to the play back, and
verify that the operation occurred as you intended.
You can press the [UNDO] key to return to the state prior to
executing this operation. (→p.26)
Operation
] key.
] key. To use the
47