Rear Panel - Dell PowerVault LTO4-120 User Manual

Amber/Solid
Amber/Solid
Amber/Solid
Amber/Solid
Amber/Flashing once
per second
Amber/Flashing twice
per second
Amber/Flashing once
every 2 seconds
4. Eject button. The eject button enables you to perform several functions. These functions are described in detail in

Rear Panel

Figure 4. Rear Panel of Internal SAS Tape Drive
1. Legacy Power Connector
2. SAS connector
Figure 5. Rear Panel of External SAS Tape Drive
1. Power connector
2. SAS connector
Back to Contents Page
Display Error Off
Code
Solid Character On/Off
Flashing once On/Off
per second,
Display of 0
Flashing once On/Off
per second,
Display option
Solid Character Off
Solid Character Off
Off Off
blinking when the drive completes the
recovery and is ready for a read or write
operation. To eject the cartridge, press
the Unload button.
Displaying error code on SCD at
maintenance mode option 9.
The tape drive is in maintenance mode.
Exit from maintenance mode.
Executing the selected option while in
maintenance mode.
If flashing once per second, an error
occurred and the tape drive or media may
require service or it may require cleaning.
Note the code on the single-character
display, and then go to the error code
table in the troubleshooting section to
determine the meaning of the error codes.
If a appears on the SCD, a cleaning
cartridge must be loaded.
If flashing twice per second, the drive is
updating firmware.
If flashing once every 2 seconds, the drive
detected an error and is performing a
firmware recovery. It will reset
automatically.
"Using the Tape Drive."