Korg TRINITY HDR-TRI User Manual page 54

4 Press the OK button, and the dialog box at
right will appear.
Start recording on your DAT recorder.
5
Press the OK button in the dialog box. The
6
data will begin to be output, and backup
will begin.
Within approximately 10 seconds, the level
meter on your DAT recorder will begin to
move.
If audio devices are connected to your DAT recorder, make settings so that
the sound from the DAT is not output to speakers or headphones. Speakers
or headphones may be damaged if this precaution is not taken.
7 When the backup is finished, the display will indicate Complete. When this
display appears, stop your DAT recorder.
If you press the Cancel button during backup in an attempt to create a par-
tial backup, the backed-up data will be incomplete, and even if this data is
restored it will be unusable.
1–4C: Restore from DAT
This command restores backed-up data from DAT tapes to the hard disk(s).
Connect the S/P DIF IN connector located on the rear panel of the TRINITY to
the DIGITAL OUT (coaxial) connector of your DAT recorder.
TRINITY
S/P DIF IN
Load the tape containing the backup data
1
into your DAT recorder.
2 When you choose Restore from DAT, the
dialog box at right will appear.
Playback your DAT recorder.
3
4 When the header of the DAT tape has been
read, the dialog box at right will appear.
Stop your DAT recorder within 30 seconds.
(Do not rewind the DAT tape.)
If you do not stop the DAT recorder within
30 seconds, restore cannot be performed
correctly.
Connections for restoring
DIGITAL OUT Your DAT recorder
(Coaxial)
Disk P1
51