Elastic Blindhem; Sewing On Patches And Appliqués - Pfaff 260C Owner's Manual

Elastic blindhem

The blindhem stitch is used to make invisible hems on
skirts, trousers, draperies and more. The elastic
blindhem stitch is especially suitable for stretchy fabrics,
because the zigzag in the stitch lets the stitch stretch, but
it can also be used on woven fabrics. Use foot number 3.
1. Finish the edge of the hem if sewing on a woven
fabric. There is no need to finish the raw edge first
on most knits.
2. Fold and press the hem allowance to the wrong side.
3. Fold the hem back on itself so approximately 3/8"
(1 cm) of the finished edge extends beyond the fold.
The wrong side of your project should now be
facing up.
4. Place the fabric under the presser foot so that the
fold runs along edge guide A.
5. When the needle swings into the fold it should
catch a small amount of fabric. If the stitches are
visible on the right side, adjust edge guide A by
turning adjusting screw B until the stitch that
catches the hem just barely shows.
Sewing on patches and appliqués
To cover large holes it is necessary to sew a new piece of
fabric onto the damaged area. Baste the new piece of
fabric onto the damaged area on the right side of the
fabric.
Sew over the fabric edges with the zigzag or the three-
step zigzag stitch. Trim the damaged area close to the
seam from the wrong side of the fabric.
For decorative appliqués, pin or baste the appliqué to
your fabric/project and sew around the edges with
zigzag, three-step zigzag, closed overlock stitch or pin
stitch.
Elastic blindhem stitch 11
Right side of fabric
27