Setup; Turning The Power On/Off; Connecting The Ac Adapter; Turning The Power On - Korg microX Operation Manual

Turning the power on/off

Connecting the AC adapter

You must use only the included AC adapter.
Using any other AC adapter may cause
malfunctions.
Note: Make sure that the microX's power switch is
set to STANDBY (the outward position).
1. Connect the plug of the included AC adapter to
the power connector on the microX's rear
panel.
2. Connect the power cable to the AC adapter.
3. Plug the power cable into an AC outlet.
4. To prevent the plug from being pulled out
accidentally, wrap the AC adapter cable
through the cable hook located on the rear of
the microX. Be careful not to bend the base of
the plug unnecessarily.
Connecting the AC adapter
4 Cable hook
AC adapter
2
Plug into an AC
outlet
3 Power cable

Setup

Turning the power on

1. Turn the microX's [VOLUME] knob toward the
2. Press the rear panel Power switch to turn on
3. Turn on your powered monitors or stereo amp.
Power switch
4. Turn the microX's [VOLUME] knob to an
1 Power connector
Note: The state of microX when the power is
Be careful not to
bend this portion
turned on will depend on the setting of "Power
excessively when you
On Mode" (GLOBAL 0: System, Preference page).
wrap the cable
(☞p.88)
through the cable
hook.
left.
If you have connected powered monitor
speakers or a stereo amp, turn down the
volume of these devices.
the power.
The display will show the model name,
software version.
(The following graphic shows the factory-set
display. The version number is subject to
change without notice.)
appropriate position, and adjust the volume of
your powered monitor speakers or stereo amp.
23