Selecting The Bar; Specifying The Program; Selecting The Tempo - Korg BeatLab BTL-1 Owner's Manual

of the chain while it is being replayed.

Selecting the bar

You can select a bar to start replay there or to
change the program set there.
(1) When a chain is being replayed, press the
START/STOP key to stop it. No bar can be
selected while a chain is being replayed.
(2) Press the parameter selection key positioned
under "BAR."
(3) Enter the bar number using the
or the numeric keys. Specify the bar number
by two digits. You can select from the bars
where programs are specified to ones where
the end command is specified (for which the
LC display shows "- -").
In the chain configuration on page 13, for ex-
ample, bars 1 to 16 in Chain 1 have preset
programs, so you can select from bar 1 to
bar 16.
In Chain 2, programs are preset to bars 1
and 2, and the end command, to bar 3, thus
you can select from bar 1 to bar 3.
14

Specifying the program

(1) When a chain is being replayed, press the
START/STOP key to stop it. No program can
be preset while a chain is being replayed.
(2) Press the parameter selection key positioned
under "PROG."
(3) Enter the program number using the
gram number by two digits.
Entering zero causes the LC display to indi-
and keys
cate "- -" and the end command to be speci-
fied. Note, however, that the end command
cannot be specified to bar 1.
"EDIT" appears on the LC display when the
setting is changed.

Selecting the tempo

(1) Press the parameter selection key positioned
under "TEMPO."
(2) Enter the tempo using the
the numeric keys. Specify the tempo by three
digits. If not, press the TAP key twice or more
to specify the intermediate time as the tempo.
keys or the numeric keys. Specify the pro-
and
and keys or