Table of Contents
Advertisement
7. Mounting / connection
The device equipped with the 50 x 50 mm housing cover can be integrated
into almost all currently available flush switch installation frame systems
when using DIN 49075 compliant intermediate frames. The device equip-
ped with the 55 x 55 mm housing is, likewise, suited for use with different
frame systems. If using multiple frames, the controller needs always to be
mounted in the lowest position. The controller is determined for installation
in an UP box and may not be exposed to any heat or cold sources. The con-
troller must not be exposed to direct cold or heat sources. Furthermore, care
must be taken to ensure that the device is not exposed to the influence of
foreign heat or cold sources that warm or cool the device at its back
(through air flows in cavity walls or the temperatures radiated by ascending
pipelines, f. ex.). The controller should be mounted on the wallpaper / the
wall covering.
Caution: Prior to performing any installation works, always make sure
to disconnect the mains voltage at all poles! The electrical connection is
controller configuration variants", are being called up all automatically. The
device will only be operable after having made correct entries.
to be realised as shown in the
connection diagram in section 8
herein. The plug-type terminals
can comfortably be pre-wired for
this purpose and connected to the
controller while installing it into
the under plaster box. The ope-
ning of the device is realised as
described in the drawing below by
holding the housing cover at the
top and bottom and pulling it
open. After first start-up, the
experts
"Language" and 6.1, "Selection of
35
menu
items
6.2,
Advertisement
Table of Contents
