Installing In Windows Networks (Peer To Peer Printing Via Netbios); Installing The Tcp/Ip Protocol - Kyocera Printserver Installation Manual

3.2 Installing in Windows Networks (peer to
peer printing via NetBIOS)
Procedure

3.2.1. Installing the TCP/IP Protocol

Print Server Installation Manual

Installing in Windows Networks (peer to peer printing via NetBIOS)

In this section, the installation of the KYOCERA-PrintServer for
peer-to-peer Printing based on NetBIOS (SMB) in Windows
networks is described. The installation in the different
environments is very simular, only the individual steps differ
sligthly.
Before beginning the actual installation, you should have basic
knowledge of TCP/IP. Please read the "Basic Terminology"
section on page 1-2 if necessary.
The print server is installed in the following steps:
Installing the TCP/IP Protocol
Saving the IP Address in the Print Server
Configuring the NetBIOS Parameters
Setting Up the Printer
To install your print server in a Windows network for peer-to-peer
printing, first the TCP/IP protocol must be installed on every
computer that is used for printing. The procedure differs
depending on the Windows system. For the installation in
Windows 98 and 95 networks read the "Installing the TCP/IP
Protocol" section on page 3-12. For the installation in Windows
3-3